[. . . ] A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the machine and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. [. . . ] To remove the battery cartridge, pull out the set plate on the machine and grasp both sides of the cartridge while withdrawing it from the machine. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. If the cartridge does not slide in easily, it is not being inserted correctly. Never use it for other purposes or for other manufacturer's batteries. When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it may not accept a full charge. You can recharge the battery cartridge fully after discharging it completely and recharging a couple of times. When you charge a battery cartridge from a justoperated machine or a battery cartridge which has been left in a location exposed to direct sunlight or heat for a long time, let it cool off. When you charge a new battery cartridge or a battery cartridge which has not been used for a long period, sometimes the charging light will go out soon. If the charging light goes out within one minute even after repeating this procedure a couple of times, the battery cartridge is dead. If you leave the battery cartridge in the charger to prevent spontaneous discharging after full charge, the charger will switch into its ``trickle charge (maintenance charge)'' mode and keep the battery cartridge fresh and fully charged. Always stop machine operation and charge the battery cartridge when you notice less machine power. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective markings on the battery charger. When the battery cartridge is inserted, the charging light color will flash in red color and charging will begin. If you leave the battery cartridge in the charger after the charging cycle is complete, the charger will switch into its ``trickle charge (maintenance charge)'' mode. After charging, remove the battery cartridge from the charger and unplug the charger from the power source. Important: Always be sure that the machine is switched off and the battery cartridge is removed before adjusting the angle head. Adjust the angle head to the desired position and reinstall it so that the teeth on the housing will match up with the grooves in the angle head. CAUTION: Before inserting the battery cartridge into the machine, always check to see that the switch lever actuates properly and returns to the ``OFF'' position when released. [. . . ] 7 & 8) Straight heads and ratchet heads are available as optional accessories for various applications on the job. Förbrukad kraftkassett skall lämnas in till särskilt uppsamlingsställe för batterier eller till auktoriserad Makita-verkstad. CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. [. . . ]